ATMP weapons carrier build thread
this is a fierce little buggie
this is a fierce little buggie
Fully loaded all the ammo boxes and jerry cans
This wheels dry fit for the final form
50 cal mounted on turret ring and GPMG mounted on front swivel arm
This GPMG tiny parts are really a struggle
details on the 50 cal is amazing for a plastic moulding
50 cal mounted on the ring
50 cal completed
50 cal mounted on turret ring
50 cal mounting assembly
50 cal before mounting
50 cal and mounting parts
Meeting of the brothers
Rear spare wheel and tire mounted on the tailboard
Mounting for rear spare wheel and tyre
Parts for rear spare wheel mounting and tyre
Front left smoke launcher mounted
Parts for front left smoke launcher
Front left smoke launcher assembly
Jerry cans baskets and mounted on the left
Jerry cans basket assembled and parts
Front center roll bar assembled
Left GPMG mount parts
Front winch and bumper with center roll bar
Front winch on the bumper bar
Front winch and bumper bar parts
Front bumper bar and winch cover parts
Front bumper bar parts
Front winch assembly
Front winch assembly parts
Front winch parts
Comments
15 27 December 2021, 14:41
Kace Wong
Completed finally the 50cal and GPMG mounting less the PE works. This kit is not for the faint hearted, challenging, heartening to see it coming together. Next few step are more wheels and accessories to pin on…
Completed finally the 50cal and GPMG mounting less the PE works. This kit is not for the faint hearted, challenging, heartening to see it coming together. Next few step are more wheels and accessories to pin on…
6 January 2022, 16:47
Alan NG
I am building this as well, I had spotted a few problems, the major one is three set of smoke dischargers are required for this version, but there are only two sets of Dk18, the base and Dk5, the smoke grenades?
Another problem is the cradle for the Browning MG, Ba8 only has half of its base and also Ba1 is missing the horizontal piece of the mount itself, but they are easy fix.
Many parts are wrongly numbered so as PE parts, so make sure to read the instructions a few steps before applying glue / cement to make sure you have the correct parts!
Otherwise, an interesting build and the ATMP is a lovely vehicle!
I am building this as well, I had spotted a few problems, the major one is three set of smoke dischargers are required for this version, but there are only two sets of Dk18, the base and Dk5, the smoke grenades?
Another problem is the cradle for the Browning MG, Ba8 only has half of its base and also Ba1 is missing the horizontal piece of the mount itself, but they are easy fix.
Many parts are wrongly numbered so as PE parts, so make sure to read the instructions a few steps before applying glue / cement to make sure you have the correct parts!
Otherwise, an interesting build and the ATMP is a lovely vehicle!
6 April 2022, 11:58
Album info
This build thread follows the step-by-step construction specifically on the WMIK (weapon mount installation kit) upper structure. The ATMP construction could be found on another album together with the SLLPT build.
scalemates.com/profi..bums&album=74746