Ferrari 126C2 - GP Belgium 1982 - WIP

First I cleaned up the 20 or so sinkmarks, and I fixed the PE side skirts. 

I removed the plastic suspension arms because they will be replaced by PE parts. The top of the cockpit also received some aftermarket parts. 

The lower cockpit half received PE bulkhead, pedals and radiators. 

The rear wing had been stripped of all the plastic deatil since it will be replaced by PE parts. The dashboard also received a PE part. 

Dryfit of the cockpit... 

Dash has been painted, decalled and weathered. 

Brake cilinders have been scratched and painted, weathered and fixed. 

Rear wing reveived PE part, rear wing support as well. The plastic endplates are replaced by PE. 

Fixing the PE radiators at the bottom... 

Dryfit of the dashboard. 

Next the exterior PE parts are fixed. Unfortunately they don't fit very well... 

With all the PE aprts in place, and lined up as they should (see lines 1-1 and 2) there is a problem at the hub top (see question mark). 

The bottom fits ok though. 

Again, the problem area which is situated at the top of the central hub. I have to find a solution. 

With the cowling in place, the problem is invisible. But I want to show the car without the cowling in place! 

This picture showed me the solution: the central hub has an extra reinforcement on top, which I will scratch to hide the problem. 

So I scratched 2 aluminium reinforcement strips, polished them and fixed them over the erroneous area... 

Picture from the rear... 

Close-up of the reinforcement strip at the right side...